Apply power after all connections have been made.Connect the chassis ground lug to a known earth ground circuit (such as building steel) to ensure that the control system is grounded properly.The control system may be powered with the included 24 VDC power supply or via Cresnet® network power with the NET port.Use Crestron power supplies for Crestron equipment.Observe the following when connecting the control system: Make all necessary connections to the control system as shown below. Place onto a flat surface or stack with other equipment.Attach the four adhesive rubber feet near the corners on the underside of the control system.Mount the control system into the rack with four mounting screws (not included).Attach the two included rack ears with the removed screws.Use a #1 Phillips screwdriver to remove the six required screws from the control system assembly (shown in the illustration below).The control system occupies 1U of rack space. The control system may be mounted into a rack or placed onto a flat surface. Use the following procedures to install the CP4 and CP4N control systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |